Pics of J&S install??

[bj]

This info is great! I have a couple more rookie questions about the install. I'm going to try and make all the connections at the ECU since it seems easier (except for the knock sensor itself of course). I think I've found all the appropriate wires with the exception of the black-yellow wire that is supposed to supply power to the unit. I see where the wire comes out of the ICM under the hood but not where it goes into the ECU (can't really figure it out for sure from the Helm manual either). I'm guessing there are some other power supply wires inside the passenger area other than what might go into the ECU but anyone have any specifics? Also, since I need to wire the knock sensor under the hood I'm having trouble locating the right grommet in the firewall to thread the wire through. I think I found the one that the ECU uses but I can only see it from under the hood (behind the battery)...I can't locate it from inside the passenger area (somewhere behind the glove box??). Oh well, hopefully some of this blabber makes some sense. Any advice is definitly appreciated. BTW, this is on a '95 gs-r.

[Mr Rogers]

I have a 98 and I used all wiring inside the engine compartment so I can't help on the engine bay wiring. As for the wires inside, the yel/blk wire you want is in the upper right hand corner of the 32P connector, it is located directly to the right of a blk ground wire. To get through the grommet, remove the rubber cover and force a wire hanger through the hole, then connect the blue wire and pull back through. If anyone has more question email, I might be able to help.